In this article
Check integrated LUFS and true peak on the same version of your video. Integrated LUFS estimates loudness over the programme. True peak estimates the highest point of the reconstructed waveform, which can occur between digital samples. Use the first reading to check the overall level and the second to check the ceiling in your delivery brief.
Start with the delivery requirements
Write down the destination, the loudness target and the maximum true peak if the recipient specifies them. EBU R 128 treats programme loudness and maximum true peak as separate measurements. Its broadcast recommendation has a specific context, and the EBU publishes separate guidance for different delivery types. Use your recipient’s requirements when available. If the brief gives no numbers, keep the readings for comparison between versions and check that the exported dialogue is comfortable to hear on the intended devices.
Measure the full mix in one pass
Put a meter on the final output after the processing you intend to export. Reset it, then measure from the start of the delivered section to the end, including the intro and outro. If you play only the voiceover or the loudest ten seconds, you are answering a different question. Record the integrated LUFS and maximum dBTP together. Note where the peak occurs if your meter or analysis tool can show it. Mark that point in the edit so you can listen to it with the surrounding audio.
Do the arithmetic before raising the mix
Imagine a 45-second product demo with a hypothetical brief of −16 LUFS integrated and a ceiling of −1 dBTP. Your first pass reads −19 LUFS and −2 dBTP. Three decibels of gain would bring the loudness roughly toward the target, but the same gain would move the true peak to about +1 dBTP in the calculation. That is 2 dB above the ceiling. If the peak comes from a logo sting at the end, lower that sting first. If it comes from voice and music peaking together, listen to the balance and adjust the track that causes the problem.
Preserve how the mix sounds
After reducing the offending peak, apply only the gain the project needs and measure again. If you use a true peak limiter, audition the loud moments and the short pauses around them. Frequent limiting can soften hits or make the mix feel as if it surges. If that happens, revisit individual levels. Play the quietest line with the music on, too. A compliant overall reading can coexist with a masked word. Use Tong’s guide to music under voiceover if the voice needs space under music.
Check the exported file before sending it
Measure the actual delivered file again because encoding and export settings can affect the result. Listen through the loud event and the quiet line in the exported version. Save the destination, file name and final readings with the approved edit. Consult and for definitions and production guidance, and for more creator workflows.
